Assembly / Before Commissioning; Start Up - Scheppach FS3600 Original Bedienungsanleitung

8. Assembly / Before commissioning

m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Fig. 3 - 5
Your machine is not completely assembled for pack-
aging reasons.
1. Remove the machine from the packaging and
place carefully to one side on the ground.
2. Unscrew the star knob screw (A) and fold the sup-
porting feet down. Re-tighten the star knob screw
(Fig. 3)
3. Place the machine on the feet.
4. Install the handle onto the motor housing using 2
hexagon screws (B) (Fig. 4).
5. Secure the cooling water pump (13) into the pre-
scribed position in the pan (4)
6. Fill the pan until the water pump is completely
covered with water. Ensure that the discharge is
sealed securely.
9.

Start up

m ATTENTION!
Always make sure the product is fully assembled
before commissioning!
On/Off switch (Fig. 4)
To switch on, press "I" on the On/Off switch (16). Before
starting the cutting process, wait until the cutting wheel
has reached the maximum speed and the cooling water
pump (13) has delivered the water to the cutting wheel.
To switch off, press the "0" on the switch (16). (Fig. 4).
Attention: The cutting wheel must always be cooled
with water.
Attention: Cutting wheel runs on.
Do not brake the cutting wheel by applying lateral
pressure.
• During normal use, the motor housing may become
hot.
• Do not force the machine or an accessory to do the
work of a larger industrial machine. It does a better
job with the performance it was designed for.
• Make all machine settings with the machine
switched off.
• Never leave the machine unattended when it is run-
ning.
• When shutting down, only leave the machine after it
has come to a complete standstill.
• Always switch the machine off before unplugging the
mains plug.
• Always unplug the mains plug. Never pull the plug
out of the socket using the cable.
• Do not use a cutting wheel that does not match the
specified sizes.
• Never carry the machine by the cable.
• Replace damaged or cracked cutting wheels imme-
diately.
If you are not sure whether working conditions are safe
or unsafe, do not work with the machine.
90° cuts (Fig. 6 - 7)
1. Loosen the star screw (C).
2. Set the transverse cutting gauge (6) to 90° and
re-tighten the star screw.
3. Tighten the wing screw (D) to fix the transverse
cutting gauge (6) into position. (Fig. 6)
4. Use the handle (11) to push the machine head (1)
backwards.
5. Place the tile on the stop rail (7) on the transverse
cutting gauge.
6. Use the handle (11) to push the machine head (1)
to the required cutting depth and fix the machine
head again.
7. Switch on the tile cutter. Attention: Wait until the
cooling water has reached the cutting wheel (10).
8. Use the handle (11) to pull the machine head (1)
slowly and evenly forwards through the tile.
9. Switch the cutting wheel off again once you have
finished cutting.
45° diagonal cut (Fig. 8)
1. Set the angled stop (6) to 45°
2. Perform cutting as described above.
45° longitudinal cut (Fig. 9)
1. Loosen the star knob screw (E) on both sides
2. Angle the guide rail (8) 45° to the left on the angle
scale (17).
3. Re-tighten the star knob screw (E) on both sides.
4. Make the cut as described.
www.scheppach.com GB | 27