Silvercrest SRR 3.7 C3 Bedienungsanleitung Seite 23

Place the three shaving heads in the recesses of the cutting
–
2
unit . Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening.
Place the round blades into the shaving heads with the blade
–
tips to the front.
Press the two tabs of the retainers together and place them
–
back into the catches of the cutting unit
The cutting unit
5) Remove loose hairs from the shaver with the brush
6) Replace the cutting unit
into place and is seated firmly.
■ Clean the housing with a moist cloth.
NOTE
► If...
... the shaving result is noticeably poorer, ...
–
... you have to the shave the same spot repeatedly
–
to achieve a good result, ...
... the shave takes much longer than usual, ...
–
... there is visible damage to the shaving heads, ...
–
... the shaving heads/the cutting unit
You can order the cutting unit
our customer service (see section "Ordering spare parts").
To replace the cutting unit
1) Take hold of the cutting unit
grip recesses
2) Fit the new cutting unit
snaps into place and is seated firmly.
│ GB │ IE
■ 18
2
is now reassembled.
2
on the shaver. Ensure that it snaps
2
, incl. shaving heads from
2
proceed as follows:
2
3
and pull it off.
2
onto the shaver. Ensure that it
2
and release the tabs.
e
2
must be replaced.
with three fingers in the
.
SRR 3.7 C3