Connection To The Mains; Replacing The Lamp - Tecfrigo Isola BRINA Zusammenbau Und Betrieb

6. CONNECTION TO THE MAINS

1. Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
2
to the appliance. . Ensure that the supply socket has the following characteristics
earthed. It fulfils the requirements of the rated current as set out on the rating plate.
b)
the IEC regulations:- Magnetothermal differential switch (also known as ground fault interrupter) with In =
nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA. 3. Ensure that there
is no risk of explosion (AD) in the room.
for internal use. 5. Insert the plug (do not use three-way adapters and reduction adapters) (see figure 4).
7. CONTROLS
The appliance is supplied with adjusting controls situated in a protected panel on the front. . 1 Cover lift
switch: to open and close the cover - Position II to lift.- Position O to stop.- Position I to lower
switch:
to switch on the internal lights
4 Thermometer: . to read the temperature in the appliance.
appliance. a) Press button
by pressing button 6 "UP"
8. CHECKING CORRECT OPERATION
CHECK THAT: 1.
The plug is connected.
3. The thermometer shows the desired temperature for the goods to be stored. . Appliance not exposed
to direct sunlight or to high-powered lamps. . The room temperature does not exceed that in which the
appliance is designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
9. CLEANING THE STAINLESS STEEL SHELF
1. Wait for the shelf to defrost completely, (BRINA-RUGIADA models). . Clean the shelf with a soft
sponge and neutral detergents.

10. REPLACING THE LAMP

1 Switch off the appliance.
the lamp socket, whilst holding the fluorescent tube and the transparent protective cover.
protective cover out of the other lamp socket. . Replace the fluorescent tube. . Refit everything in the
initial position (see figure 6).
11. ACCESS TO THE MOTOR COMPARTMENT
Simply remove the ventilation grilles to access the motor compartment.
Operator's guide
4.
The connecting cable to the appliance is H05 VVF, designed
. 3.
Refrigeration unit switch: to switch on the refrigeration unit.
5 "SET or P"
once to display the temperature set-pint, which can be changed
or button 7 "DOWN" (see figure 5).
2.
The refrigeration unit switch is switched on (green light ON).
5
3.
Dry with a clean cloth.
2. Open the cover. 3. Undo the fastening screws of a lamp socket.
6
7
: a) It is properly
Thermostat: to adjust the temperature in the
4
2
7
It complies with
c)
2. Light
4. Remove
5.
Slide the
SLO
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK