Maico elicent RECduo 100 Gebrauchsanweisung Seite 65

DESCRIPTION AND PERSONALIZATION OF THE REMOTE CONTROL
The product is a radio transmitter designed for operating the REC DUO PLUS RC heat recovery.
ACTIVATING THE TRANSMITTER
Remove the transparent pull tab from the remote control battery compartment.
From then on the remote control is enabled to operate in a radius of approximately 20m with the battery in a good functio-
ning state.
To synchronise the remote control with the product, refer to the product instructions.
DESCRIPTION OF CONTROL
0 - ON / OFF
1
Device on/off.
1 - PUSH-PULL MODE
1
24 h operation at the set speed. Automatic: operation with alternating
flow.
2 - SPEED 1
1
Low speed setting.
3 - SPEED 2
1
High speed setting.
4 - TIMER-SET BOOST
2
(only on the device(s) paired with the remote control)
Timer-set operation in ejection only at maximum speed.
5 - SLEEP MODE
1
Maintains the selected operating mode at the set speed 1. To exit
this mode before the end of the 8 hours, press any key (except 0).
6 - FORCED FLOW CONTROL
The devices operate either in ejection only or in injection only.
Press once: ejection mode.
Press twice: injection mode.
7 - FREE COOLING (no inversion)
No inversion of flow.
Press once: flow inversion stops in the direction of rotation active at
that moment.
Press twice: all the devices invert flow and maintain this set direction
of rotation.
: FUNCTION THAT CONTROLS ALL PRODUCTS PAIRED WITH THE REMOTE CONTROL.
1
: FUNCTION THAT CONTROLS THE SINGLE PRODUCT PAIRED WITH ITS OWN REMOTE CONTROL (not valid if
2
only one remote control is used on several devices - see paragraph "PAIRING A REMOTE CONTROL WITH SEVERAL
VENTILATION UNITS").
SPECIFIC FUNCTIONS OF THE REMOTE CONTROL REC DUO PLUS RC SPECIFIC FUNCTIONS OF THE REMOTE CONTROL REC DUO PLUS RC
RESTORE FACTORY SETTINGS
○ Press for a few seconds and simultaneously release the 0, 1, 6 and 7 KEYS on the remote control. The LED will flash
RED and PURPLE. When they stop flashing, the devices will return to the previous mode, but with the factory-set
values.
CUSTOMISATION OF FACTORY SETTINGS
To increase and/or decrease the limit values, press and release the keys repeatedly as shown below.
1
1
LED
SIGNAL: every time
a button is pressed
sequentially, on the
remote
0 1
LED light will indica-
te that the command
has been received.
2 3
4 5
6 7
INDICATION
control an
63