Inhaltsverzeichnis
Werbung
used for debugging only.
Hot Surface
parts.
This sticker is to indicate that the
marked item can be hot and should
not be touched without taking care.
Wait one-half hour after switching off
before handling parts.
The device with this sticker is
intended for installation in a
restricted access location. Access can
only be gained by service persons or
by users who have been instructed
about the reasons for the restrictions
applied to the location and about any
precautions that shall be taken.
Installation
Install the equipment according to
the instructions in this manual.
To prevent injury, this equipment
must be securely attached to the
installation surface in accordance
with the installation instructions.
Make sure that the power has been
disconnected before you wire, install,
or disassemble the device.
Transportation
Keep the device in original or similar
packaging while transporting it.
Do not drop the product or subject it
to physical shock. Keep the device
away from magnetic interference.
Power Supply
Use the power adapter provided by
qualified manufacturer. Refer to the
product specification for detailed
power requirements. It is
recommended to provide
independent power adapter for each
device as adapter overload may
cause over-heating or a fire hazard.
System Security
CAUTION: Hot
parts! Burned
fingers when
handling the
Please understand that you have the
responsibility to configure all the
passwords and other security settings
about the device, and keep your user
name and password.
Maintenance
If the product does not work properly,
please contact your dealer or the
nearest service center. We shall not
assume any responsibility for
problems caused by unauthorized
repair or maintenance.
Cleaning
Please use a soft and dry cloth to
clean the interior and exterior
surfaces. Do not use alkaline
detergents.
Using Environment
DO NOT aim the lens at the strong
light such as sun or incandescent
lamp. The strong light can cause fatal
damage to the device.
To avoid heat accumulation, good
ventilation is required for a proper
operating environment.
DO NOT expose the device to
extremely hot, cold, dusty, corrosive,
saline-alkali, or damp environments.
For temperature and humidity
requirements, see device
specification.
Emergency
If smoke, odor, or noise arises from
the device, immediately turn off the
power, unplug the power cable, and
contact the service center.
Time Synchronization
Set up device time manually for the
first time access if the local time is
not synchronized with that of the
network. Visit the device via Web
browse/client software and go to
time settings interface.
L'image du produit est
donnée uniquement à titre
9
Français
Werbung
Inhaltsverzeichnis
