BVS CA - SF2 - _ _ _ _ _ _ - _ _ _ _ _ _ - XAS2
2 USER INSTRUCTIONS
2.3
Abbreviations
2.4
Copyright
2.5
Legal requirements
www.matrix-vision.com
www. matrix-vision.com
ADC
Analog-to-digital converter
BVS
Balluff Vision Solutions
CA
BVS Industrial Camera
CMOS
Complementary metal-oxide-semiconductor
DHCP
Dynamic Host Configuration Protocol
EEPROM
Electrical Erasable and Programmable ROM
EMC
Electromagnetic compatibility
FCC
Federal Communications Commission
FPGA
Field Programmable Gate Array
GenICam
Generic Interface for Cameras
GND
Ground
GUI
Graphic User Interface
I/O-Port
Digital input / output port
IO
Input / Output
IP
Internet Protocol
LAN
Local Area Network
LLA
Logical Link Address
MAC
Media Access Control
NC
Not connected
PC
Personal Computer
PLC
Programmable Logic Controller
RGB
Red Green Blue
RX
Receiver
TX
Transmitter
USB3 Vision
Image processing standard for USB3 interfaces
Copyright © MATRIX VISION GmbH, Oppenweiler, Germany, 2022. All rights reserved.
In particular: Right to duplication, modification, dissemination and translation into other
languages. Please note that all texts, graphics and images contained in these operating
instructions are protected by copyright and other protection laws. Commercial duplica-
tions, reproductions, modifications and disseminations of any type require the prior writ-
ten approval of MATRIX VISION GmbH. All information and notes in these operating
instructions, particularly the chapter Safety Instructions, must be observed.
The General Terms and Conditions of MATRIX VISION GmbH in their respective current
version and the conditions in these operating instructions exclusively apply to all deliver-
ies of products and to all other services of MATRIX VISION GmbH (henceforth referred
to as "GTC"). The provisioning of the software is exclusively subject to the respective
current GTC, the conditions in these operating instructions as well as the regulations of
the "Enduser Licensing Agreement". You may use the software only in compliance with
these provisions. If they should not yet be available, MATRIX VISION GmbH will gladly
provide the current GTC upon request.
The driver of the BVS Industrial Camera uses a variety of freely available tools which
were published under various open source licenses. Some licenses require that the
source code and modifications be published. These sources are published on the Prod-
uct homepage.
The license texts for all software products used can be downloaded from the web inter-
face along with the manuals. They are available as ZIP files.
5