Display Messages - Dometic TEC30D EV Bedienungsanleitung

TEC30D EV
8.6

Display messages

Display message
Description
LOW BATTERY
The battery voltage has fallen
below the minimum value for
starting up (9V).
OIL CHANGE
The number of prescribed
operating hours has been
reached for changing the
engine oil.
NO FUEL
The fuel in the tank is in
reserve.
CHECK OIL LEVEL
Insufficient engine oil.
OIL TEMP PRESS
Insufficient engine oil.
OIL TEMP PRESS
Engine temperature too high.
GENERATOR ALERT!
General alarm message
OVERLOAD!
The consumers generate an
overload at the output.
EN
Generator behaviour
The generator does not start.
The generator continues to
run.
The generator continues to
run.
The generator stops.
The generator stops.
The generator stops.
The generator stops.
The inverter switches off,
therefore no voltage is sup-
plied but the engine carries
on running until it goes off.
Operating the generator
Measures
Charge the battery.
Change the oil (see chapter
"Changing the oil" on
page 23), then restart the
generator by pressing and
holding down the start button.
Refuel.
Fill up with oil (see chapter
"Checking the oil level" on
page 21).
Fill up with oil (see chapter
"Checking the oil level" on
page 21).
Switch off the generator and
leave it to cool down. Check
that the ventilation openings
aren't obstructed.
If the problem persists,
contact the manufacturer's
branch office in your country
(addresses on the manual's
back page).
Check the system by referring
to the troubleshooting table
(page 26).
If the problem persists,
contact the manufacturer's
branch office in your country
(addresses on the manual's
back page).
Reduce the connected load.
Stop the generator and restart
it.
19