Battery Type; Package Contents; Intended Use - DeWalt XR LI-ION DCS355 Originalanweisungen

EngLIsh
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other
e
than the designated D
D WALT charger may make them burst or lead to
e
other dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

The DCS355 operates on a 18 volt battery pack.
These battery packs may be used: DCB181, DCB182, DCB183,
DCB183B, DCB184, DCB184B, DCB185, DCB546. Refer to
Technical Data for more information.

Package Contents

The package contains:
1 Adaptor for all blades
1 31 mm x 43 mm Fastcut wood blade
1 Sanding-pad
1 31 mm x 43 mm Wood with nails blade
1 Rigid scraper blade
1 Blade adaptor hex key
1 Instruction manual
1 Dust extraction adaptor
1 Cutting guide
1 100 mm Semicircle blade
25 Assorted sandpaper pieces
1 9.5 mm x 43 mm Wood detail blade
1 3 mm Carbide grout removal blade
(100 mm half moon)
1 Cutting guide hex key
1 Charger
1 TSTAK kitbox
DCS355D1/DCS355M1:
1 Li-Ion battery pack
DCS355D2/DCS355M2:
2 Li-Ion battery packs
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
34
WALT batteries with a
e
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Wear respiratory protection.
Date Code Position (Fig. A)
The date code 20 , which also includes the year of manufacture,
is printed into the housing.
Example:
2016 XX XX
Year of Manufacture
Description (Fig. A, B)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Variable speed trigger
1
LED Worklight
2
Accessory clamp lever
3
Lock on/off button
4
Accessory side mount slots
5
Cut guide block
6
Cut guide arm
7
Battery pack
8
Battery release button
9
Fuel gauge button
10

Intended Use

This oscillating multi-tool is designed for professional detail
sanding, plunge cutting, flush cutting, removal of excess
materials and surface preparation applications.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This oscillating multi-tool is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.