MSW Motor Technics MSW-RBM-250 Bedienungsanleitung Seite 22

other condition that may affect the safe operation of the device). If damaged,
have the device repaired before use.
f) Keep the product out of the reach of children.
g) Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
h) To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i) When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
j) Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
k) Do not touch any moving parts or accessories unless the device is unplugged.
l) Do not move, shift, or rotate the device while in operation.
m) Do not leave the device switched on unattended.
n) Clean the device regularly to prevent permanent dirt build-up.
o) Do not process two workpieces at the same time.
p) Do not tamper with the device to alter its performance or design.
q) Keep the unit away from sources of fire and heat.
r) Do not overload the device.
s) Do not exceed the maximum permissible operating pressure of the unit!
t) Do not block the ventilation openings of the unit!
u) If the device in use emits disturbing sounds, heats up excessively or emits
smoke, stop using it immediately and contact the manufacturer's service.
CAUTION! Although the product has been designed to be safe and
has adequate safeguards and despite the additional safety features
provided to the user, there is still a slight risk of accident or injury
when handling the product. Caution and common sense are advised
when using the product.
3. Instructions for use
The device is designed for bending bars, e.g. reinforcing bars.
The user is responsible for any damage resulting from misuse.