BRUKSBO LX system 20V Bersetzung Der Original Bedienungsanleitung Seite 8

that the saw blade is securely fixed and that
the teeth are pointing in the cutting direction.
3. Let go of the clamping lever. Check whether
the back of the saw blade is positioned in the
centre of the guide roller (10). Make sure to
use the right sawblade for the corresponding
material. Included with the machine is a coarse
sawblade for wood and a fine sawblade for
metal and plastics.
Removing the saw blade
1. Turn the clamping lever (13) as far to the left as
possible and hold it in this position.
2. Remove the saw blade from the chuck (16).
3. Let go of the clamping lever.
Attaching the parallel guide
Fig. C
1. Loosen the bolts (14).
2. Mount the parallel guide (19) onto the
baseplate (9).
3. Set the desired cutting width using the scale
on the parallel guide (19) and the cutting mark
on the baseplate (9). The cutting mark (21)
indicates the position of the saw blade.
4. Tighten the bolts (14).
4. OPERATION
Switching the machine on/off
Fig. A
The on/off switch (2) is used for activating the
machine and adjusting speed.
• To start the machine, press and hold the lockoff
button (1) and press the on/off switch (2).
• The further the on/off switch (2) is being
pushed, the faster the blade will move.
The required speeds depends on the material
and can be determined by practical testing.
• To stop the machine, release the on/off switch
(2).
Adjusting the bevel angle
Fig. A, D
1. Loosen the bolts (18), using the hex key (15).
2. Adjust the baseplate (9) to the desired position
(0°- 45°). The sawing angle (bevel) can be read
on the scale (7).
3. Tighten the bolts (18), using the hex key (15).
It is possible to store the hex key onto the
machine, as shown on Fig. A.
8
Adjusting the pendulum action
Fig. A
The pendulum action switch (6) is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions:
0 - No pendulum action
1 - Small pendulum action
2 - Medium pendulum action
3 - Large pendulum action
The required pendulum action can be determined
by practical testing, although the following
instructions can be observed:
• Soft material (wood, plastics etc.): set the
pendulum to level II or III. For a finer and
cleaner saw cut, use pendulum level 0 or I.
• Thin material, use pendulum level 0.
• Hard material (hardwood, steel etc.): set the
pendulum to level 0.
• Curves: set pendulum to level 0.
Dust extraction
Fig. E
• Insert the dust extraction adapter (8) into the
dust extraction connection (22).
• Connect the hose of a vacuum cleaner to the
dust extraction adapter (8).
Plunge cutting
Fig. G
Plunge cutting may only be used on soft materials
such as wood, aerated concrete, gypsum plaster
boards, etc. However, this requires a certain
practice and is only possible with short saw
blades.
1. Place the saw onto the workpiece and switch it
on.
2. Ensure that the bottom edge of the footplate
rests on the workpiece surface as shown on
Fig. G.
3. Slowly saw into the workpiece at an angle,
moving the saw to a vertical position and
continue to saw along the cutting line.
4. Switch the saw off and lift off the workpiece
when the work is complete.
Optimum use
• Clamp the workpiece. Use a clamping device
for small workpieces.
• Draw a line to define the direction in which to