Makita UR014G Betriebsanleitung Seite 8

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Handle type
No load speed
Overall length
(without cutting tool and battery)
Nylon cord diameter
Applicable cutting tool and
cutting diameter
Rated voltage
Net weight
Protection degree
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Recommended cord connected power source
Portable power pack
• The cord connected power source(s) listed above may not be available depending on your region of residence.
• Before using the cord connected power source, read instruction and cautionary markings on them.
Noise
Applicable standard : ISO22868(ISO11806-1)/EN50636-2-91
Nylon cutting head
• Even if the sound pressure level listed above is 80 dB (A) or less, the level under working may exceed 80 dB
(A). Wear ear protection.
NOTE: The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
Nylon cutting head
(P/N 1911Y3-7)
Cutting tool
D.C. 36 V - 40 V max
BL4020 / BL4025 / BL4040 / BL4050F* / BL4080F*
* : Recommended battery
DC40RA / DC40RB / DC40RC
Sound pressure level (L
pA
L dB(A) Uncertainty (K)
pA
dB(A)
77.9 2.9
8 ENGLISH
UR014G
Loop handle
-1
0 - 5,000 min
1,857 mm
2.7 mm
450 mm
5.5 - 6.7 kg
IPX4
PDC01 / PDC1200
) dB(A) Sound power level (L
L dB(A)
WA
91.3
) dB(A)
WA
Uncertainty (K)
dB(A)
1.9