Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
The device is equipped with a lockable power input connector. Fix the mains cable and turn it to the right
until it locks. Connect the device via the mains cable to a grounded mains socket. Thus the unit is
switched on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
After you connected the device to the mains, the LED THA-450F Theater Spot starts running.
During the reset, the motor is trimmed and then the device is ready for use.
You can choose the desired setting via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.
Stand-alone mode
In the stand-alone mode, you can do without a controller.
Disconnect the theater spot from the controller.
Rotary dial instructions
The Dimmer and Zoom rotary dials are located on the side of the device, as listed under the chapter
Description of the device.
Dimmer-Dial: Press the Dimmer dial and you can adjust the brightness step by step, while at the same time
the Zoom dial enables faster brightness settings. Press the Dimmer dial again and you're back in DMX
mode.
Zoom-Dial: Press the Zoom dial and you can adjust the zoom step by step, while at the same time the
Dimmer dial enables faster brightness settings. Press the Zoom dial again and you're back in DMX mode.
(both rotary dials work together):
30/44
00144838, Version 1.0