Installation - Dometic Oceanair Skyscreen Powered Montage- Und Bedienungsanleitung

Installation

7 Installation
!
WARNING! Risk of injury
• Disconnect the power supply before you begin and ensure that it can not
be reconnected until installation has been completed.
• Assemble and fit the frame the with two people if the blind is large or the
mounting location is difficult to reach alone.
7.1 Frame assembly (only flat pack version)
A
NOTICE! Damage hazard
• When unpacking, leave the blue tape on the side tracks to aid assembly.
• The end of belt must be kept packaged until it is assembled to the moving
rail to prevent crushing.
• Ensure that the frame is not twisted during installation, as distortion will
damage the blind and affect the operation of the blind.
Proceed as follows:
1. Slide grommet away from coupling and loosen the coupling from the shaft
of the head rail (fig. 2, page 3).
2. Unscrew locking ring on two part spline coupling (fig. 2, page 3).
3. Slide male part away from female part to disengage shaft (fig. 2, page 3).
4. Push belt through housing sprocket (fig. 3, page 4 and fig. 5, page 5).
5. Assemble the head rail to the side track noting the correct belt channels to
use (fig. 3, page 4 to fig. 6, page 5).
6. Ensure the gliders are at the same distance from the frame (fig. 7, page 6).
7. Re-assemble the couplings on the shaft (fig. 8, page 6).
7.2 Frame fitting
A
NOTICE! Damage hazard
• Use packing material where required (fig. 9, page 7).
• Use suitable screws and plugs for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.The heads of screws may be no
larger than 6.0 mm in diameter.
• Ensure not to drill through the wall.
• Ensure not to damage the channel in the side tracks.
• Take care not to leave screws or other debris inside the side tracks as this
can jam the shoes in the tracks.
Proceed as shown:
1. Align the blind with the window cut-out and mark where the holes are to be
drilled for the frame.
16
Skyscreen Powered
EN