Hilti SIW 2-A12 Bedienungsanleitung Seite 34

As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Installing an accessory tool
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Do not use worn or damaged accessory tools.
1. Clean the connection end of the accessory tool.
2. Push the accessory tool fully on to the tool holder.
3. Check that the accessory tool is held correctly.
6.2 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (switch-on interlock).
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Switching on
▶ Press the control switch.
▶ Speed of rotation is regulated by the distance the control switch is
pressed in.
6.4 Switching off
▶ Release the control switch.
28 English
2
3
2384752
*2384752*