ATH-Heinl ATH Cross Lift 40 Bedienungsanleitung Seite 90

5. Electrical connection
Lay all electrical cables between the control box and the lifting platform and connect them according to the
numbering or plugs.
The limit switches of the lifting platform are only connected electrically in this step. Please do not mount
them on the lift until later.
Attention
Here, the general as well as the local regulations must be observed.
Therefore, this step should only be carried out by a trained specialist. Pay attention to the
necessary supply line (see
Note
The corresponding
operating manual.
6. Bleeding the hydraulic circuit
The instructions for bleeding the circuit can be found in the chapter
Attention
Before the system is put into operation or operated with oil for the first time, the following
must be observed with regard to optimum and trouble-free operation:
a) Almost air-free system
b) Hydraulic lines are connected and tightened according to the hydraulic plan and hose
c) A minimum oil quantity of 20 liters is required
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
90
"Electrical
"Electrical circuit diagram"
designation, if applicable.
Release date: 05.04.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
connection".).
can be found in the appendix of this
"Before commissioning".