BRAYER BR2009 Bedienungsanleitung Seite 9

Notes:
- working surfaces (3, 4) are double-sided, one side
is «flat», the other side is «grooved», choose the
desired side and install the working surfaces into
the grill;
- The working surfaces (3, 4) are fixed with
magnets, before turning on the grill, make sure
that the working surfaces (3, 4) are securely fixed;
- before removing the working surfaces (3, 4), make
sure that they are cold.
• Insert the power plug into the mains socket.
• Turn the temperature control knob (10) and set the
temperature from «MIN» 100°C to «MAX» 230°C.
• Turn the operating time setting knob (11) and set the
grill operating time up to 60 minutes, meanwhile the
grill will turn on and the indicators of the knobs (10,
11) will light up.
Notes:
- if necessary, you can turn the grill on to a constant
mode of operation, to do this, turn the operating
time setting knob (11) counterclockwise to the
«ON» position;
- at the end of the set operating time of the grill, a
short signal will sound, the grill will turn off and the
indicators of the knobs (10, 11) will go out.
• Wait for the heating of the working surfaces (3, 4),
the indicator of the temperature control knob (10) will
go out.
• Take the handle (6) and open the grill.
• Carefully put the products on the lower frying plate
(3), avoid burns by possible splashes of juice or fat
dripping from the products.
• Take the handle (6) and lower the upper frying plate
(8) on the products.
Note: depending on the thickness of the cooked
products you can adjust the clearance between the
frying plates (3, 4). To do this, move the lock (7) handle
to the required position «
• After you finish cooking, take the handle (6) and lift
the upper frying plate (8).
• Put the prepared products into an appropriate dish;
use wooden or heat-resistant plastic kitchen tools to
remove the products.
• To turn the grill off in an emergency, turn the
operating time setting knob (11) and set it to the «0»
position, unplug the power cord from the electrical
outlet.
Using the grill as a cooking unit (pic. 1)
• You can use the grill as a flat frying surface.
• Before connecting the power plug to the mains
socket open the grill. To do this, take the handle (6)
and lift the upper part of the grill.
• Press the button (8) «180°» and open the grill
completely.
• Insert the power plug into the mains socket.
• Turn the temperature control knob (10) and set the
temperature from «MIN» 100°C to «MAX» 230°C.
EN
» (pic. 2).
9