logo located on the front of the product are facing you or your friend's face. Feed the
top of your hair (near the scalp) on the small recess at the front of the product, wrap
the hair pass the barrel and down through the deep aperture at the back, (C), then hold
the appliance around 50-75mm away from your head. (A)
• Choose the direction of the curl by pressing the right or left curling button (feature
3) as shown in diagram D. Work on one side of the head at a time. When you move on
to the other side, press the opposite direction curling button so that your curls are
symmetrical (D).
D
• VERY IMPORTANT - Please do not put your fingers in the deeper aperture at the back of
the product or try to touch the hot barrel.
• Feed the top of your hair (near the scalp) on the small recess at the front of the
product, wrap the hair pass the barrel and down through the deep aperture at the back,
then press and hold the curling button. The hair will be automatically wrapped around
the heated barrel.
• Keep holding the button while the hair is wrapped around the barrel and until you hear
the audible beep.
• The curling system stops and a beep is heard after 15 seconds which is sufficient time
to curl normal hair.
• THE PRODUCT MAY JAM IF TOO MUCH HAIR IS FED AROUND THE BARREL. In this case, the
product will automatically shut off. Simply lower the autocurler vertically downwards to
release the hair and turn back on again to continue using.
• After hearing the beep, release the curl button. The
rotating clip will have stopped, and you can lower the
autocurler vertically downwards from the hair to release
your curl.
• Caution! When the curling mechanism has stopped, always
lower the autocurler vertically downwards to release the curl.
• Repeat for each hair section, allowing each curl time to
cool in between.
• For long hair, curl the hair section as described above.
When you hear a beep and the curling system has come
to a stop, gently lower the autocurler to release the hair. When you reach the middle of
a hair section, repeat the curling process. The end result will have the full-length hair
section beautifully curled from top to bottom.
• After use, switch off the appliance and allow to cool before storing away. There will be
an audible "beep" to signal the product is turned off.
Follow us on www.revamphair.com for the latest hair tips and advice.
Please note:
• When the product runs out of charge, it will turn itself off with an audible "beep" signal.
• Avoid over-use of styling products as this may deteriorate the coating on the barrel.
• The heated barrel and top end of the appliance get very hot during use. To avoid burns,
keep the barrel away from direct contact with the head and only hold the appliance by
the handle.
• While heating, during use and cooling, place on the REVAMP stand or on a heat resistant
surface. Only hold the product by the cool handle.
• Do not scratch the surface of the curl barrel as this will deteriorate the effectiveness of
the coating.
• The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.
CLEANING & MAINTENANCE
• Switch the appliance off and allow to cool fully before cleaning.
• Wipe over all surfaces using a soft damp cloth. Do not use harsh abrasives or cleaners.
B
D