Using The System With Ice Bottles; Applying Therapy Wraps And Pads - Breg VPULSE Bedienungsanleitung

Operating Instructions

Using the System with Ice Bottles

If your VPULSE includes the Ice Bottle pair or you purchased them as an accessory, please follow the
instructions below to prepare the Ice Bottles for use.
1. Fill the Ice Bottle with tap water. Freeze the
filled Ice Bottle for a minimum of 6 hours in any
household freezer to ensure maximum cold
therapy.
The time the Ice Bottle will stay frozen is
approximately 2 to 6 hours. Use additional Ice
Bottles for longer treatment.
Fill Ice Bottles with water only
1
Remove the two Ice
Bottles from the
container.
3
Freeze Ice
Bottles.
To avoid skin irritation or cold burn, DO NOT hold frozen Ice Bottles for an extended period.
DO NOT use the Ice Bottles directly on skin for therapeutic purposes.
5
Place the two Ice Bot-
tles into the container.
10 of 23
2. Place the frozen Ice Bottle into the container.
Make sure water is already in the VPULSE unit
up to the water line. For longer duration of
sustained cold water temperature, add ice in
addition to the Ice Bottle to the water reservoir
(as desired). Only fill the Ice Bottles with water.
To order additional Ice Bottles please call
1.800.321.0607 or 1.760.795.5440.
2
Fill Ice Bottles
with water.
4
Pour cold
water into the
container to the
"WATER" level
indication on
the inside of the
container.
6
Place the lid onto
the container and
turn clockwise until
the handle clicks into
position.
Operating Instructions

Applying Therapy Wraps and Pads

Apply therapy pads only to body part indicated for the associated pad. failure to follow the
product instructions may lead to improper product performance and the potential for serious
injury.
Apply the Sequential Compression Therapy pads to the patient's calves.
1 2
Center the pad behind the Wrap one side of the pad, as
patient's calf. shown, around the front of the
patient's leg.
Apply 1 Cold-Dynamic Compression pad to the appropriate body part (Example: knee)
(Refer to the other available pads for the application instructions for each pad.)
4
Center the pad over the patient's knee with the
connector pointing down.
Attach the Container to the pads via the tubing set.
6
Attach the container to the pads using the
corresponding colored connectors as shown. The
connectors make a "click" sound when fastened
properly.
3
Secure by wrapping the 3 "fingers" in the
order shown around to the front. Apply
pads to both calves. Adjust so snug. Do not
over tighten.
5
Wrap straps around the knee to secure the pad.
7
Plug the container into a grounded AC outlet.
11 of 23