Initial Setup - AENO EG5 Bedienungsanleitung

Carry the unit by holding it by the base only. Large quantities of food placed in
the device make it difficult to close the lid. Do not press the lid too hard as this
could damage the device. Only remove cooked food from the plates with a
heat–resistant spatula. Do not use forks, knives, or other sharp kitchen
appliances to avoid damaging the non–stick coating of the removable plates.
Do not leave the appliance in operation unattended. Always unplug the
appliance after use or before cleaning it. To prevent burns, do not remove the
drip tray (8) with the contents until the appliance has cooled down completely.
Do not repair the appliance yourself, contact an authorized service center. Do
not make any modifications to the appliance or its components.

Initial setup

Unpack the appliance, remove the grease drip tray (8). Remove the plates (6)
and (7) by pressing the respective (upper or lower) release buttons (4).
Wash the plates and the drip tray with neutral detergent, wipe them dry and
refit them. Install the plates so that the grease chute (10) faces backwards: the
grease should flow into the drip tray. Place the appliance on a heat–resistant
base and in a well–ventilated area at least 30 cm away from other objects.
NOTE. The removable plates are interchangeable and reversible: one side has
a ribbed surface and the other is flat. Cooking can be done on either side. When
using them for the first time, grease the outer cooking surface of the removable
plates with a thin layer of cooking oil. If you subsequently cook on the other
side of the plates, apply a layer of cooking oil to the other side as well when
using it for the first time. This will ensure that the non–stick coating works best.
Exploitation
Close the grill and plug it in. Immediately afterwards, an acoustic signal sound.
All the indicators on the control panel (3) light up and go out (see figure c). You
8 aeno.com/documents