Specifications; Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-65SC1 Installationsanleitung

Model
Power requirement
Operating temperature *
Operating humidity
Power consumption (Maximum)
Dimensions (excluding protrusions) inch (mm) Approx. 59-7/8 (W) x 3-7/8 (D) x 37-1/2 (H) (1521 x 99 x 952)
Weight
* Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases,
please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.

Mounting Precautions (For SHARP dealers and service engineers)

• When installing, removing or moving the monitor, ensure
that this is carried out by at least 4 people.
• Be sure to use a wall-mount bracket designed or
designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall
or pillar. Reinforced work might be necessary for some
materials such as plaster / thin plastic board / wood before
starting installation.
This monitor and bracket must be installed on a wall which
can endure at least 4 times or more the weight of the
monitor. Install by the most suitable method for the material
and the structure.
• To attach a VESA-compliant mounting bracket, use M6
screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm)
longer than the thickness of the mounting bracket.
3/8 - 1/2 inch (10-12 mm)
• Do not use an impact driver.
• After mounting, please carefully ensure the monitor is
secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than VESA holes for
installation.
• When moving the monitor, be sure to hold it with the
handles and the unit bottom. Do not grasp the screen or
tray. This may cause product damage, failure, or injury.
8
E

Specifications

PN-65SC1
AC 100 V - 240 V, 2.4 A, 50/60 Hz
41°F to 95°F (5°C to 35°C)
20% to 80% (no condensation)
205 W
lbs. (kg) Approx. 126.8 (57.5)
Screws (M6)
Mounting bracket
Monitor mounting
• If you need to temporarily place the monitor on a table or
other surface during installation, spread a thick soft cloth on
the table to prevent damage to the screen and table.
• Prior to repacking or removal, remove the tray.
nAttaching the Tray
Secure the tray using 2 tray mounting screws (M3) (supplied).