Instruction Manual; Intended Use - Makita LS1040 Bedienungsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. Miter angle
Max. Bevel angle
No load speed
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W) with blade 260 mm in diameter
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
For all countries other than
European countries
For European countries
Bevel angle
0°
45° (left)
LS1040 / LS1040S
25.4 mm, 25 mm or 30 mm (Country specific)
530 mm x 476 mm x 532 mm
11.8 kg
0°
93 mm x 95 mm
69 mm x 135 mm
53 mm x 95 mm
35 mm x 135 mm
To loosen the bolt, turn it clockwise.
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
8 ENGLISH
LS1040F / LS1040FS
255 mm - 260 mm
30 mm
3.2 mm
Left 45°, Right 52°
Left 45°
-1
5,100 min
12.0 kg
/II
Miter angle
45° (left and right)
93 mm x 67 mm
69 mm x 95 mm
49 mm x 67 mm
35 mm x 94 mm