Installation; Using The Spa - Bestway LAY-Z-SPA S300202 Gebrauchsanweisung

INSTALLATION

For the installation instructions, follow the drawings printed on the package. Drawings are for illustration purposes only. May
not reflect actual product. Not to scale.
RECOMMENDATIONS DURING THE INSTALLATION
• Keep the spa away from the rest area to minimize noise disturbance.
• Keep at least 1m clearance around the spa.
• We don't recommend using sea water to fill the pool. Sea water can corrode the internal metal components due to the high concentration of salt.
• The filtration system of the spa is designed to be used only with the filter cartridge. Any other component added inside the filter set can cause damage
to the filtration system of the spa. This will not be covered by customer service.
INFLATION INFORMATION
• When inflating, you will notice that air will be expelled from the area where the air hose connects to the pump, this is normal for technique requirements.
• Don't cover the holes on the base of the inflation hose. This operation will over inflate the liner and damage the structure.
• Do not use an air compressor to inflate the spa.
• Do not drag the spa on rough ground as this may cause damage to the spa liner. Inflation time for reference only.

USING THE SPA

CONTROL PANEL
LOCK/UNLOCK BUTTON: The pump has a 5-minute auto-lock, this light will turn on. To lock or unlock the pump, press the lock/unlock
button for 3 seconds.
POWER-SAVING TIMER BUTTON: Designed to help avoid wasting power by setting the time and duration of the heating cycle for the spa.
follow these steps to activate the POWER-SAVING function.
Press the button and the
Press the or
Press the button again to confirm the heating duration.
After setting the heating duration, the
Press the or
function. If the timer is set to 0 hour, the heating system will activate immediately.
Press button again or simply touch nothing for 10 seconds to confirm the setting. The
heater activation will begin. The screen flashes the current temperature and time alternately.
To modify the timer settings: Press the
Cancel the setting: Press the
When the power saving function is activated, all other functions (massage, filtration) except the heating can be used.
The POWER-SAVING function in not an automatic function: after one complete cycle (waiting time plus heating function), this function
must set again.
HEAT BUTTON: Press
button is red, the heating system is activated. When the light is green, the water reached the
set temperature.
When the heating system is activated, the filtration system will automatically start, and the
button will turn on; rotate the air suction valve to the locked position
After turning off the heating system, the filtration system will continue to operate.
HYDROJET MASSAGE SYSTEM BUTTON: Press the
HydroJet function, and the light of the
to the unlocked position
after 1 hour.
Do not run the HydroJet System without water.
MASSAGE SYSTEM BUTTON:Press
The light of the button becomes red when activated.
Do not run the massage system when the cover is attached, air can accumulate inside the spa and cause irreparable damage
to the cover. Heat and massage system can be activated at the same time.
2-LEVEL MASSAGE REGULATION: Push once for the full power massage; the display will show L1. Push it again for a lower power
massage; the display will show L2. Push it a third time to shut the massage function off.
LED starts to flash.
button to adjust the heating duration (From 1-999 hours).
LED starts to flash.
button to set the time (From 0-999 hours). This setting defines the waiting hours before the activation of the heating
button and use the
button for 2 seconds.
button to activate the heating system. When the light of the
button will turn red. Rotate the air suction valve
, for maximum power. The system will shut off automatically
button to activate the massage system, which has a 30-minute auto-shutoff feature.
or button to adjust.
.
button to activate the
15
LED will light steadily, and the countdown to
Air Suction Valve