Taurus ICONIC DIGITAL ADVANCE Bedienungsanleitung Seite 11

ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig.4)
- Close the lid of the dust box.
CHANGING THE FILTERS:
- Dust tank filter, it is advisable to be changed
at least once a year or every 50 hours of the
appliance's use.
- Air outlet HEPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use.
TO REMOVE THE FILTERS:
- Remove the filter from the tank, turning the
bottom part of the tank (O) to the left and remo-
ve the cyclone from inside the tank by pulling it
out. You can see that the filter is located inside
the cyclone. (Fig.5)
- Remove the outlet EPA filter, open the cover by
pressing the button to remove the outlet filter
cover (M) (Fig.6).
- To assemble the filter, proceed in reverse order
as explained in the previous section.
IMPORTANT: Filters washable with water, but
they must be left to dry for at least 24 hours in the
sun before using them again.
CLEANING THE ROTARY BRUSH (C1/C2):
- TO REMOVE THE BRUSH:
- TURN THE ROTATING BUTTON ON THE
SIDE OF THE FITTING TO THE LEFT IN
ORDER TO RELEASE THE BRUSH (FIG.7)
- TAKE OUT THE ROLLER AND CLEAN WITH
THE CLEANING TOOL (P) INCLUDED IN THE
PRODUCT.
- TO REASSEMBLE, FOLLOW THE ABOVE
INSTRUCTIONS BUT IN REVERSE.
SUPPLIES:
- Supplies can be acquired from distributors
and authorised establishments (such as filters,
etc...) for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist
shops.
HOW TO REMOVE THE BATTERIES FROM
THE INTERIOR OF THE DEVICE:
- CAUTION: It is important that the batteries are
fully discharged prior to its withdrawal from the
apparatus.
- CAUTION: the appliance must be disconnec-
ted from the supply mains when removing the
batteries.
TO REMOVE THE BATTERIES, ONCE THE
LIFE OF THE APPLIANCE, PROCEED AS
FOLLOWS:
- Safely remove the battery from its housing by
pressing the two side buttons on the battery
(D), located at the rear of the vacuum cleaner.