Transport, Packaging And Storage - MR CEDASPE VT Serie Betriebsanleitung

4. Transport, packaging and storage

4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -40 ... +60 °C [-40 ... +140 °F] (DIN EN 13190)
■
Humidity: 35 ... 85 % relative humidity (non-condensing)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Store the instrument in its original packaging in a location that fulfils the conditions listed
above.
If the original packaging is not available, pack and store the instrument as described
below:
▶
Place the instrument, along with the shock-absorbent material, in the packaging.
WARNING!
Physical injuries and damage to property and the environment
through residual media
Residual media at the dismounted instrument can result in a risk to
persons, the environment and equipment.
▶
Before storing the instrument (following operation), remove any residual
media.
▶
For cleaning the instrument, see chapter 7.2 "Cleaning".
Operating instructions for expansion thermometer, CEDASPE VT series
®
EN
11