Explanation Of Terms; Half Cylinder - Assa Abloy KESO Integra Installations- Und Montageanleitung

Term
Knob
I
(electronic
side, outside)
1 Knob cover
2 Special tool
(optional)
3 CR2 battery
4 Locking
washer
Guide
5
6 Safety sleeve
7 Turnbuckle
screw
8 Cylinder
housings
9 Knob
mounting
10 Battery
compartment
11 USB interface The USB interface will be utilised for setting up the cylinder with the V3
12 Turning aid
(optional)
EN
36

Explanation of terms

Half cylinder

Description
Knob on the electronic side consisting of: · Knob cover (
The knob cover serves as a cover for the knob cylinder.
The knobs can be released with the help of the special tool.
The CR2 battery is used for the power supply for the electronic knob cylinder.
The locking washer is screwed to the knob holder on the respective side. It has a
flattening and a point shaped marking which must point towards both sides in
the direction of the cylinder housing.
The guide on the locking washer will ensure correct assembly of the knob.
The safety sleeve will be pushed onto the part of the knob spindle protruding
from the cylinder housing. It is used to guide in the connecting cable (Flex con-
nector) onto the cylinder housing (
The turnbuckle screw is utilised to secure the profile cylinder in the mortise lock.
The cylinder housing will be assembled in the door via the turnbuckle screw (
When you have removed the knob, the connecting cable (FlexConnector) to
the battery compartment (
The knob mounting will attach the knob on the respective side and is then
screwed on with the locking washer
biguous possibility of attachment, which is determined by the position of the
locking washer.
The battery compartment will be screwed to the knob spindle via the knob
9
mounting ( ). A 3 V CR2 (
compartment.
programming device and for firmware updates.
The turning aid will be pushed over the knob after assembly. It facilitates
turning the knob and can be purchased as an accessory.
· Battery compartment (
· Knob mounting (
8
).
10
) will appear.
4
). There is therefore only one unam-
3
) battery must be inserted in the battery
1
),
10
) and
9
).
7
).
Explanation of terms