Brita PURITY 450 Steam Handbuch Seite 33

•
If this button is pressed (> 10 seconds), the data set on initial
installation will be accepted again, and the capacity, bypass
setting and input date are all updated.
Note: This automatically sets the monthly limit to 12 months.
Note: If no input is made within 30 seconds, the display will return to standby or operating mode
without accepting amended parameters.
Insert the display unit from the front at a height of approx. 10 mm and slide down. The loops on the
display part must be inserted in the grooves on the measuring head.
6.1 Removing the Filter Cartridge
•
Switch off power supply to the terminal device (remove plug).
• Close inlet valve
•
Place the flushing hose in a bucket and remove pressure from the filter system by opening the
flush valve. Catch the escaping water in a bucket.
Note: If the escaping water is more than 1 litre, the inlet valve
blocked with scale.
•
•
Place the pressure vessel lid
Note: Do not turn the lid horizontally on its head.
•
Stand on the kick loops
the mantle handles
•
Take your feet off the kick loops
the mantle handles
•
Remove exhausted filter cartridge
•
Place the exhausted filter cartridge
remaining water (> 5 min.).
• Lock the exhausted filter cartridge
cartridge and return in the original packaging to the appropriate BRITA address listed on the
back of the cover.
6.2 Inserting the Filter Cartridge
•
•
•
•
at inlet hose .
7 6
Stand on the kick loops
lid by pressing the lock
3
vertically on both lid handles
3
with both feet while turning the pressure vessel
12
as far as it will go.
16
and press the pressure vessel
12
.
16
from the pressure vessel
2
in the sink with the connection facing down to drain the
2
with the transport protective cap
2
Check the connector seat of the filter cartridge O-ring
lid for dirt and damage.
1
Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
Place the new filter cartridge
Stand on the kick loops
clockwise until the mantle handle
7
with both feet while opening the pressure vessel
12
and turning it anticlockwise as far as it will go.
15
.
20
in the pressure vessel
2
with both feet, lift the pressure vessel
12
is over the kick loops
16
is not completely closed or is
anticlockwise by
1
down with both hands on
1
.
1
of the new filter
18
in the pressure vessel
2
is correctly seated in the
2
.
1
turning it
1
.
12
EN
29