Transport; Cleaning, Maintenance And Storage; Troubleshooting; Cleaning - Parkside PSTDA 20-Li B3 Originalbetriebsanleitung

GB
3. Press the On/Off switch (2).
✔ The LED work light (22) lights up.
4. Release the switch lock (1).
Switching off
1. To turn it off, release the on/off switch (2).
2. Do not pull the sawblade out of the cut until
it has come to a standstill.
3. Remove the rechargeable battery from the
device if you are leaving the device unatten-
ded or if you have finished working.

Transport

Information on transporting the device:
• Switch off the device and remove the re-
chargeable battery. Make sure that all mov-
ing parts have come to a complete stop.
• Remove the attachment tool.
• Always carry the device by the handle.
Cleaning, maintenance
and storage
WARNING! Electric shock! Protect your-
self when performing maintenance or cleaning
work. Turn off the device.
You should have any repair and maintenance
work that is not described in these instructions
carried out by our Service Centre. Only use ori-
ginal replacement parts.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Machine does not start
Machine works with interrup-
tions
30

Cleaning

WARNING! Electric shock Never spray
down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents or
solvents.
• Keep the ventilation slits, motor housing and

Maintenance

The device is maintenance free.

Storage

Always store the device and accessories:
• clean
• dry
• protected against dust
• In the case provided (31)
• out of the reach of children
The storage temperature for the rechargeable
battery and the device is between 0°C and
45°C. Avoid extreme cold or heat during stor-
age to ensure the battery output is not ad-
versely affected.
Remove the rechargeable battery from the
device before storing the device (see the sep-
arate operating instructions for the battery and
charger).
Possible cause
Rechargeable battery (28) not
inserted
On/Off switch (2) is broken
Rechargeable battery (28) dis-
charged
Defective motor
Internal loose contact
On/Off switch (2) is broken
handles of the machine clean. Use a damp
cloth or brush to do this.

Error correction

Inserting the battery (Fig. G), p.
29
contact the service centre.
Charge the battery (see the sep-
arate operating instructions for
the rechargeable battery and
charger)
contact the service centre.
contact the service centre.
contact the service centre.