Küppersbusch DDL9830.0W Bedienungsanleitung Mit Montageanweisungen Seite 35

Hood is not working
Hood aspirates little air
Green LED flashes for 20
seconds
Red LED flashes for 20
seconds
No electricity
Remote control is not synchronised
with the hood
Electrical system problems
On/off switch is in position 0
Soiled aluminium filters
Metal grease filter cleaning indicator
Long-life or ceramic filter cleaning
indicator
Check the power cable.
Synchronise the remote control as
described in the user manual from page
20.
Check the power supply on the
electronic board.
Set the on/off switch to position 1 as
shown on page 4, Picture 4 of the
instruction manual.
Remove the filters as shown on page
11, Picture 17 of the operating manual
and wash the filters.
Reset the filters when the hood is
turned off pressing the "P0" button on
the remote control for 3 seconds while
the LED flashes as shown on page 22 of
the instruction manual.
Reset the filters when the the hood is
turned off pressing the button "P0" on
the remote control for 3 seconds while
the LED flashes as shown on page 22 of
the user manual.
35