Setting Up Rotoforce-1 On Rotopol-11; Rotoforce-1 On Rotopol-21/22/25 - struers RotoForce-1 Gebrauchsanweisung

Setting Up RotoForce-1
on RotoPol-11
RotoForce-1
on RotoPol-21/22/25
4
RotoForce-1
Instruction Manual
n Remove the cap covering the support hole placed on the top of
the RotoPol-11 cabinet.
n Remove the two caps covering the fastening screws on the
left-hand side of the RotoPol cabinet by lifting them off with a
knife.
n Lead the supporting column of RotoForce-1 down into the
support hole in RotoPol-11. Turn the column until the
specimen mover plate is positioned correctly over the
preparation disc. (see figure)
n Mount a preparation disc on RotoPol-11 and adjust the
distance between disc and specimen mover plate to about
1 - 1.5 mm.
n Tighten the two fastening screws on the left-hand side of the
RotoPol-11 cabinet and mount the two caps again.
Place two working tables of equal height at a distance about half
the length of RotoPol. Balance RotoPol between the tables.
n Lead the supporting column of RotoForce-1 down into the
support hole of RotoPol.
n Turn the column until the specimen mover plate is positioned
correctly over the preparation disc.
n Fasten the nut and washer from the transportation box
loosely under the column of RotoForce-1 below RotoPol.
n Adjust the height of the specimen mover in relation to the
preparation disc:
−
Mount a preparation disc on RotoPol.
−
Mount a specimen mover plate on RotoForce-1.
−
Lower RotoForce-1 into working position.
−
Measure the distance between the specimen mover plate
and the preparation disc.
−
The correct distance should be 1 - 1.5 mm. If the distance
is not correct, remove RotoForce-1 again.
−
Grease 1 or more extra washers (1-3 mm) and place them
on the thread at the end of the column. (the grease
makes the washers stick to the column.)
−
Put RotoForce-1 back onto RotoPol and make sure the
distance is correct now.
−
Fasten the bottom nut tightly.