Operating Elements And Connections; Safety Notes - IMG STAGE LINE MPX-460 Bedienungsanleitung

Please unfold page 3. Then you can always see the
GB
operating elements and connections described.

1 Operating Elements and Connections

1.1 Front panel
1 Level control for the monitor output BOOTH (25)
2 LED VU-meter for the master signal
3 LED POWER ON
4 Input selector switches for channels 1 to 4
5 Gain controls for adjusting the input amplification
for channels 1 to 4
6 3-way equalizers (max. +15 dB/-30 dB) for chan-
nels 1 to 4:
HIGH, MID, LOW
7 PFL switches for channels 1 to 4: for prefader
listening to the corresponding channel via head-
phones connected to the jack PHONES (17)
8 Level controls (faders) for channels 1 to 4
9 6.3 mm jack DJ MIC (bal.) at the front of the unit for
connecting a DJ microphone;
connected in parallel to the 6.3 mm jack DJ MIC
(28) at the rear panel
10 Control C.F. CURVE for continuously adjusting the
characteristic of the crossfader (13)
control at the left stop ("FLAT"):
smooth crossfading (gradual transition)
control at the right stop ("ERIC")
hard crossfading (abrupt transition)
11 Selector switch (with indicating LED) for a connect-
ed DJ microphone
switch at the left ("OFF"), indicating LED is extin-
guished:
microphone is switched off
switch in mid-position ("ON"), indicating LED lights
up
microphone is switched on
switch at the right ("TALKOVER"), indicating LED
lights up
automatic level attenuation (16 dB) of channels 2
to 4 in case of microphone announcements
12 Reverse button (with indicating LED) for the cross-
fading feature: for selecting the side of the crossfa-
der (13) to which channels 2 and 3 or 4 are switched
button not pressed; indicating LED is extinguished
left side:
right side:
button pressed; indicating LED lights up
left side:
right side:
8
channel 2
channel 3 [with button C.F. ASSIGN
(16) not pressed] or channel 4 [with
button C.F. ASSIGN (16) pressed]
channel 3 [with the button C.F.
ASSIGN (16) not pressed] or chan-
nel 4 [with button C.F. ASSIGN (16)
pressed]
channel 2
13 Crossfader for crossfading between channels 2
and 3 or 4 [depending on which of the two channels
was selected for crossfading via the button C.F.
ASSIGN (16)]
14 Level control for headphones connected to the jack
PHONES (17)
15 Level control for the master signal at the master
outputs (23 and 24)
16 Button C.F. ASSIGN for selecting channel 3 (button
not pressed) or channel 4 (button pressed) for the
crossfading feature
17 6.3 mm jack PHONES at the front of the unit for
connecting stereo headphones (impedance ≥ 8 Ω)
1.2 Rear panel
18 Power switch of the mixer
19 Selector switch 1 V/ 2 V for the level at the master
outputs (23 and 24)
20 Ground clamping screws GND for turntables
connected to channels 2 to 4
21 Stereo inputs PHONO (phono jacks) for channels
2 to 4 for connecting turntables with magnetic
system
22 Jack for connecting the supplied power supply unit
23 Balanced stereo master output (XLR) for connect-
ing an amplifier
24 Unbalanced stereo master output (phono jacks) for
connecting an amplifier
25 Stereo monitor output BOOTH (phono jacks) for
connecting a monitoring system
26 Stereo output REC (phono jacks) for connecting a
sound recorder; the recording level is independent
of the position of the master control (15)
27 Stereo inputs LINE (phono jacks) for channels 1 to
4 for connecting units with line level outputs (e. g.
minidisk recorder, CD player, cassette recorder)
28 6.3 mm jack DJ MIC (bal.) for connecting a DJ
microphone;
connected in parallel to the 6.3 mm jack DJ MIC (9)
at the front

2 Safety Notes

The mixer and the supplied power supply unit corre-
spond to the directive for electromagnetic compatibility
89 / 336 / EEC. The power supply unit also corresponds
to the low voltage directive 73 / 23 / EEC.
Attention! The power supply unit is supplied with
hazardous
Leave servicing to skilled personnel only.
Inexpert handling may cause an electric
shock hazard. Furthermore, any guaran-
tee claim will expire if the power supply
unit or the mixer has been opened.
Please observe the following items in any case:
mains voltage (230 V~).