Troubleshooting
Symptom
The Jet Bot is not working at all.
The Jet Bot has stopped during
cleaning.
Suction power is weak.
The Jet Bot cannot find the
Clean Station.
The Jet Bot does not detect the
Boundary Marker and crosses
the boundary.
40
English
• Check if the power switch is on.
• Check if the Status Indicator is on.
• Check if the Jet Bot's battery is depleted.
– When the Jet Bot's Status Indicator turns red and
stays red, place the Jet Bot manually on the Clean
Station to charge it.
• When you manually charge the Jet Bot due to complete
discharge of its battery, the buttons on the Jet Bot do
not work. When charging is partially complete (about
10-20 minutes later), the Status Indicator is on and the
buttons work again.
• When the Jet Bot's Status Indicator turns red and stays
red, place the Jet Bot manually on the Clean Station to
charge it.
• When the Jet Bot is immobilized by an obstacle such as
a cord, obstacles, threshold, a raised spot, etc., pick it up
and move it away from the obstacle.
– If any fabric or string is caught in a Driving Wheel,
turn off the power switch and remove the fabric or
string before using it again.
• Check whether the No-go Zones are set.
• When there's too much dust in the Dustbin, suction
power may get weakened. Turn off the power switch
and empty the Dustbin.
• If the brush at the bottom of the Jet Bot is blocked by
foreign matter, turn off the power switch and remove
foreign matter from the brush.
• When noise suddenly increases, turn off the power
switch and empty the Dustbin.
• Check if there's a power failure or whether the power
plug is unplugged.
• Remove any obstacles around the Clean Station that may
prevent the Jet Bot from returning to the Clean Station.
• When there's foreign matter on the charging terminals,
charging can be affected. Clean the foreign matter off
the terminals.
• Make sure the Boundary Markers are attached as (
shape at 15 cm before the locations where the Jet Bot
should not cross.
Checklist
)