Meec tools 017711 Bedienungsanleitung Seite 46

EN
2. Place the parallel fence at a suitable
distance from the blade for the actual cut
and firmly lock the lever. In position 0 the
parallel fence is in line with the saw blade.
FIG. 27
3. Check that the workpiece does not go
against the blade before starting the
product.
4. When sawing long workpieces put a
support with the same height as the
saw table behind the saw to support the
workpiece.
5. Start the saw.
6. Place the workpiece flat on the saw table
with one edge firmly pressed against the
parallel fence. Allow the blade to reach
maximum speed before it makes contact
with the workpiece.
7. When the blade comes in contact with the
workpiece, guide it with the hand nearest
to the parallel fence. Make sure that the
workpiece is firmly flush with both the
parallel fence and the surface of the saw
table.
FIG. 28
FIG. 29
8. When sawing thin workpieces, use the
pusher to move the workpiece past the
blade.
9. Switch off the saw after sawing. Do not
remove the workpiece before all moving
parts have completely stopped.
MITRE SAWING
1. Remove the parallel fence.
2. Adjust the blade to the correct depth for
the thickness of the workpiece.
3. Set the mitre pointer to the required angle
and tighten the lock knob.
FIG. 30
4. Check that the workpiece does not go
against the blade before starting the saw.
46
5. Start the saw.
6. Allow the blade to reach maximum
speed before it makes contact with the
workpiece.
7. Hold the workpiece firmly with both
hands on the mitre pointer and feed the
workpiece past the blade.
NOTE:
Hold the hand nearest the blade on the lock
knob on the mitre pointer and the hand
that is furthest away from the blade on the
workpiece.
8. Switch off the saw after sawing. Do not
remove the workpiece before all moving
parts have completely stopped.
BEVEL SAWING
1. Remove the parallel fence.
2. Release the lock lever for the bevel angle.
3. Set the required bevel angle.
4. Lock the lock lever for the bevel angle.
5. Adjust the blade to the correct depth for
the thickness of the workpiece.
6. Set the mitre pointer to 0° and tighten
the lock knob.
FIG. 31
7. Check that the workpiece does not go
against the blade before starting the saw.
8. Start the saw.
9. Allow the blade to reach maximum
speed before it makes contact with the
workpiece.
10. Hold the workpiece firmly with both
hands on the mitre pointer and feed the
workpiece past the blade.
NOTE:
Hold the hand nearest the blade on the lock
knob on the mitre pointer and the hand
that is furthest away from the blade on the
workpiece.