Attaching And Securing The Body; Switching On The Vehicle - Reely Adventure Bedienungsanleitung

12.5 Attaching and securing the body

Connect the two plugs of the LEDs in the body using the appropriate plug connections.
Assignment of the two LED cables on the vehicle:
Socket with black/red cable: Connection for white headlights
Socket with yellow/green cable: Connection for red tail lights
Then place the body on the brackets and fix them with the locking clips removed at the beginning.

12.6 Switching on the vehicle

Release the throttle/brake lever on the transmitter so that
it is in the middle position. Release the steering wheel.
If you have not already done so, turn on the transmitter
using the on/off switch; the red LED will flash (the flashing
indicates that there has not yet been a connection ("pair-
ing") with the receiver).
Switch the vehicle on. The on/off switch (see arrow in the
picture on the right) is located on the underside under a
small protective rubber cover.
Switch position "ON" = switched on
Switch position "OFF" = switched off
The red LED on the transmitter must now light up continuously; the radio connection between transmitter and receiver
in the vehicle has been established (this is referred to as "pairing" with 2.4 GHz remote controls).
The vehicle is now ready to ride.
If the red LED continues to flash and the vehicle does not respond to the remote control commands, switch
off the transmitter, wait a few seconds and then switch on the transmitter again.
Release the throttle/brake lever on the transmitter (so that it is in the middle position) during the power-up
process. Release the steering wheel.
The vehicle's white headlights flash (if they are correctly connected, see cable assignment in chapter 12.5;
if the assignment is incorrect, the red tail lights flash) as long as no radio connection has been established
between the transmitter and the receiver in the vehicle.
32