Charging The Battery; Exchanging The Battery; Positioning The Solar Panel - LIVARNO home 898-S-2 Bedienungs- Und Sicherheitshinweise

holes �
20
Offer the wall bracket
„ „
mounting surface and fix it in place with
the screws �
23
Now push the solar panel/spotlight bracket
„ „
onto the solar panel wall bracket
4
until it very lightly snaps into place�
Now connect the plug of cable
„ „
socket of the extension cable
D) and then connect the plug of cable
to the charging socket
spotlight�
Now align the LED solar spotlight as
„ „
desired�
Please note: to detach the bracket again,
very carefully press the tabs on the sides of
the guide rail until the bracket can be
5
removed�
Mounting the solar panel on the ground
spike
Screw the solar panel screw fixing
„ „
the connecting sleeve
hand-tight�
Now join the LED solar spotlight
„ „
together with the ground spike
D) using the connecting sleeve
push the spike into the ground (lawn, soil,
etc�) where desired�
Please note: make sure the solar panel is
attached firmly!
Now connect the plug of cable
„ „
socket of the extension cable
D) and then connect the plug of cable
to the charging socket
spotlight�
The spotlight and solar panel are now ready
for use�
RISK OF INJURY! Make sure you remove
the ground spike when removing the
spotlight to avoid any risk of injury (e�g� trip
hazard)�
10
GB
up to the
19
19
to the
6
(see Fig�
18
18
of the LED solar
15
onto
3
and tighten it
2
11
(see Fig�
17
and
2
to the
6
(see Fig�
18
18
of the LED solar
15
z Charging the battery
The battery is charged regardless of the
„ „
position of the switch� To optimise initial
charging, charge the LED solar spotlight
while it is turned off�
Please note: the battery is fully charged after
it has been well exposed to sunlight for 6 to 8
hours� The duration of the charging process
depends on the battery's charge level and the
quality of the sunlight�
z Exchanging the battery
Loosen the screws
„ „ 25
the product� Fold the motion detector
upwards so that you can reach two of the
five screws (see Fig. I).
Carefully take the product apart� Take care
„ „
not to tug on the cables�
Loosen the screws
„ „ 25
the battery compartment
the battery compartment (see Fig� I)�
Remove the exhausted rechargeable
„ „
batteries and dispose of it in
27
accordance with applicable guidelines�
Insert new rechargeable batteries� Only use
„ „
batteries of the same type (see section
'Technical specifications'). Pay attention to
the correct polarity when inserting batteries�
Screw the battery compartment back in
„ „
place�
Put the product together again� Attention:
„ „
Make sure not to get any cables trapped
between the different parts�
Refasten the five screws.
„ „
z Positioning the solar panel
Orientation
The optimum alignment is facing south� It is
better to face the solar panel slightly to the
west than slightly to the east�
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
on the underside of
9
on the underside of
and remove
26
is
1