Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remarque
:
Use DSR400 or DSR400T consumables only. These are specially designed to provide you with optimum print
rendering.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Open the external flap located on the right-hand side of the printer.
2. Remove the protective foam.
3. Take the new ribbon out of its packaging and make sure that the film is stretched after removing
the card (A).
4. Install the ribbon in the position shown in the illustration below.
5. Lift the locking lever and push in the film cartridge until it touches the back of the compartment
the locking lever must be locked after insertion.
6. Close the external flap.
Warning -
inserted into the printer. Check that the green locking lever is correctly lowered.
Remarque
:
In the event of any difficulty, check that there are no foreign objects in the film cartridge compartment.
F
IRST RIBBON INSTALLATION
Never touch the film cartridge with your fingers. Make sure the cartridge is completely
- 4 -
A
6
Werbung
Kapitel
Inhaltsverzeichnis
