Noise And Vibration; Technical Specifications - Flex CS 45 18.0-EC Originalbetriebsanleitung

the blade or any other part, in all depths of cut.
b) Check the operation and condition of
the guard return spring. If the guard and
the spring are not operating properly,
they must be serviced before use. The
guard may operate sluggishly due to damaged
parts, gummy deposits, or a build-up of debris.
c) Assure that the base plate of the saw
will not shift while performing a "plunge
cut". Blade shifting sideways will cause binding
and likely kick back.
d) Always observe that the guard is
covering the blade before placing
the saw down on bench or floor. An
unprotected, coasting blade will cause the saw
to walk backwards, cutting whatever is in its
path. Be aware of the time it takes for the blade
to stop after the switch is released.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The evaluated noise level of the power tool is
typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
– Total vibration value
– Emission value a
– Emission value a
– Uncertainty:
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
16
: 89.3 dB(A);
pA
: 100.3 dB(A);
WA
K = 3 dB.
(cutting boards):
h,B
<1.4 m/s
(cutting sheet metal):
h,M
< 1.6 m/s
K = 1.5 m/s
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use. This may
significantly decrease the exposure level over
the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).

Technical specifications

Machine Type
U
n
o
Blade diameter
Blade bore
diameter
Max. cutting
depth
Weight
according to
"EPTA Procedure
2
01/2003"
(with battery)
2
weight battery
2
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1 Retracting guard
2 Adjusting lever for retracting guard
3 Clamping bolt with clamping flange
4 Dust extraction nozzle
5 Lock-off button
6 ON/OFF switch
7 Handle
8 Hexagon-socket key
9 Base plate
10 Clamping lever for cutting depth
CS 45 18.0-EC
CS 45 18.0-EC
Hand circular saw
Vdc 18
/min 5400
mm 128
mm 20
mm 46.5
kg 2.4
kg 0.8 kg (5 Ah)