Timer Setting - UNIPRODO UNI HEATER 09 Bedienungsanleitung

Pressing the function selection button (F) for the fourth time will, in addition to
high-power heating, additionally activate the airflow flap (D). Activation of the
airflow flap in the UNI_HEATER_09 model will be additionally signaled by an
additional indicator:
Pressing the function selection button (F) for the fifth time will turn off the heating
and switch to standby mode - the fan will turn off within the next 30 seconds. The
message "S" will appear on the display of the control panel, the same as after
starting the device (see the first pictures of the panels above), and all the indicators
will go out.

3.3.2 Timer setting

Press the timer button on the control panel (G) or the remote control (C) to set the
timer from 00-12 hours to indicate automatic shutdown - the timer light will light
up on the display (see pictures below). Each press of this button increases the time
by 1 hour. After setting the time, the display will show the currently set time for 5
seconds. Then the display will revert to showing the previous value:
3.3.3 Setting the switch-on time
In standby mode, pressing the timer button on the control panel (G) or the remote
control (C) will allow you to set the delay time for the automatic start-up of the unit
in the range of 1-12 hours. Once set, the display will show the time to switch-on and
the timer indicator will be illuminated (see the pictures below). The remaining time
will be indicated with a countdown every hour. After the set time has elapsed, the
device will start up with the default temperature of 23 o C.