Cleaning And Care - Klarfit Pacemaker X3 Bedienungsanleitung

CLEANING AND CARE

Note: Switch off the device and remove the plug from the socket before
cleaning or maintenance.
Cleaning
• The unit can be cleaned with a soft cloth and mild detergent.
• Do not use abrasive or aggressive solvents.
• Take care not to expose the computer display to excessive moisture as
this could damage it and pose a hazard.
• Make sure that the unit (especially the computer display) is not exposed
to direct sunlight as this could damage the screen.
Storage
• Store the treadmill in a clean and dry indoor environment.
• Never leave or use the unit outdoors.
• Make sure the main power switch is turned off and the power cord is
unplugged from the wall socket.
ADJUST THE TREAD
The treadmill has already been adjusted at the factory, yet all users tend to
be right- or left-footed. If the tread slips to the side, it must be adjusted. There
are 2 adjustment screws at the rear of the unit. Tighten the screw half a turn
on the side where the tape has slipped and loosen it equally on the other side.
Carefully run the tread through to make sure it is absolutely centred. Repeat
the process if the tread is still not properly centred.
• Turning clockwise moves the tread to the right. Turning anti-clockwise
moves the tread to the left.
• Turning clockwise moves the tread to the left. Turning anti-clockwise
moves the tread to the right.
Note: The treadmill should not be pulled too tightly as this could damage
the tread.
EN
29