Cleaning The Welding Torch; Annual Maintenance By An Electrician; Replacing Wear Parts, Fig. 4; Disposal - Abicor Binzel ABITIG GRIP Originalbetriebsanleitung

®
ABITIG GRIP
CAUTION
Risk of injury due to unexpected start
If the device is energised during maintenance, cleaning or disassembly work, parts can unexpectedly start up and cause injuries.
► Switch off the device.
► Close off all supply lines.
► Disconnect the electrical power supply.
7.1

Cleaning the welding torch

The parts listed below are subject to wear and soiling. As a result, they must
undergo regular maintenance and cleaning:
— Torch body
— Gas nozzle
7.2

Annual maintenance by an electrician

► Have all components (welding torch, cable assembly, spare and
wear parts) inspected and cleaned by an electrician trained by
ABICOR BINZEL. Replace if necessary.
7.3

Replacing wear parts, Fig. 4

NOTICE
Material damage through the use of unsuitable wear parts
The use of wear parts from other manufacturers and the improper installation of wear parts can cause material damage to the welding torch and impair work
results.
► Only use original ABICOR BINZEL wear parts.
► Ensure that the welding-torch-specific wear parts are correctly assigned.
► Ensure that the parts are installed in the correct order.
► Order data and part numbers for the equipment parts and wear parts
can be found in the current order documents.
8

Disposal

Tab. 4 Critical raw materials in welding torches equipped for welding
Tungsten (tungsten electrodes)
Equipment marked with this symbol is covered by European Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE).
► Do not dispose of electrical devices with household waste.
► Disassemble electrical devices before they are disposed of.
► Collect components of electrical separately and recycle in an environmentally responsible manner.
► Observe local regulations, laws, provisions, standards and guidelines.
► Please consult your local authority for information about collection and return of electrical devices.
9

Warranty

This product is an original ABICOR BINZEL product. Alexander Binzel
Schweisstechnik GmbH & Co. KG guarantees correct manufacture and
assumes a plant production and function warranty for this product upon
delivery in line with current state-of-the-art technology and the regulations in
force. If ABICOR BINZEL is responsible for a defect that occurs,
ABICOR BINZEL is obliged to remedy the defect or deliver a replacement at
its own cost and its own discretion. The warranty covers manufacturing faults,
but not damage resulting from natural wear and tear, overloading or
improper use. The warranty period is defined in the General Terms and
— Tungsten electrode
— Back cap
— Electrode holder
► In the case of extremely frequent use and/or very high current intensity
The welding torch neck can be fitted with various wear parts depending on
the welding task.
> 1 g
Conditions. Exceptions in the case of specific products are regulated
separately. The warranty will also be rendered invalid if spare and wear
parts are used that are not original ABICOR BINZEL parts and if the product
has been repaired improperly by the user or a third party.
Wear parts are excluded in general from the warranty. In addition,
ABICOR BINZEL is not liable for damage caused by using our products.
Questions about warranty and service can be addressed to the manufacturer
or our distributors. For more information, visit www.binzel-abicor.com.
and/or evident wear, shorten the interval.
8 Disposal
EN - 33