SafeMi SHG-01 Benutzerhandbuch Seite 4

The SafeMi SHG-01 gas sensor should not be installed:
 Directly above kitchen appliances (gas stove, stove, burners etc.).
 Anywhere outside.
 In an enclosed space (eg in a cupboard or behind a curtain).
 Directly above a sink and in humid places.
 Next to doors or windows.
 Next to the exhaust fan or hood.
 In an area where the temperature can drop below -10 ° C or exceed 40 ° C.
 In an area where dirt and dust can block the device.
The SafeMi SHG-01 gas detector should be installed in rooms where there is a risk of gas leakage
(e.g. kitchen, boiler room or bathroom).
1. After determining the mounting location, check the mounting surface area for hidden
electrical wiring or pipes. Mark a suitable place on the wall according to the two holes in the
sensor mounting plate (See diagram)
2. Drill two 5.0mm diameter holes in the wall, and then insert the plastic wall plugs into the
holes.
3. Attach the mounting plate with the screws provided, screwing it firmly into the pre-drilled
holes.
4. Mount the sensor on the mounting plate and pull it down until it conforms to the plate.
5. Insert the power plug into a power outlet, and the POWER LED will light. The device will
complete the preparation process in approximately 3 minutes, which is signaled by the
flashing green LED. After this time, the device will go into standby mode and will
continuously monitor the presence of gas in the air (the LED is permanently green).