Original Accessories/Auxiliary Equipment; Before Use; Assembly - Parkside PMB 1100 B2 Originalbetriebsanleitung

■ Always be vigilant, especially during repetitive,
monotonous operations. Always make sure that
your hands are in the correct position in relation
to the saw blade.
■ Never remove the workpiece stop.
■ Keep away from end pieces that fall down after
sawing. They can be hot, sharp and/or heavy.
This could result in serious injury.
■ Ventilation openings often cover moving parts and
should be kept free. Loose clothing, jewellery or
long hair can get caught in the moving parts.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in
certain circumstances, impair active or
passive medical implants. To reduce the risk
of serious or fatal injury, we recommend that
individuals with medical implants consult their
physician and the manufacturer of the
medical implant before operating the power
tool.
Original accessories/auxiliary
equipment
Only use the accessories and additional equip-
ment that are specified in the operating instruc-
tions and compatible with the appliance.
│ GB │ IE │ NI │ CY
■ 6

Before use

WARNING! RISK OF INJURY!
Always remove the power plug from
the wall socket before carrying out
any work on the appliance.

Assembly

Note that all parts are pre-assembled. The instruc-
tions only apply to possible maintenance activities.
Fitting the handle (pre-assembled)
♦ Hold the handle
(see pictures on fold-out page)
♦ Push the wing screw
and housing and tighten it.
Mounting the vice (pre-assembled)
♦ Fasten the vice in the corresponding holes
on the back of the saw table using the 4
cylinder head screws with hex socket
supplied (see fig. C on the fold-out page). Use
a 5 mm hex key (not supplied).
Mounting the cutting angle adjustment on
the saw table (pre-assembled)
♦ Completely unscrew the screw
cutting angle adjustment
through the angle recess on the saw table
from below and retighten it using the cutting
angle adjustment
page).
♦ Use a long wing screw
arm through the other hole on the saw
table (see fig. D on the fold-out page).
in the appropriate position
through the handle
from the
. Insert the screw
(see fig. D on the fold-out
to fasten the swivel
PMB 1100 B2