AEG IPE84573FB Benutzerinformation Seite 21

Problem
You cannot select the maximum
heat setting for one of the cook‐
ing zones.
You cannot activate one of the
cooking zones.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Hob²Hood does not work.
The sensor fields become hot.
There is no sound when you
touch the panel sensor fields.
The flexible induction cooking
area does not heat up the cook‐
ware.
comes on.
The control bar blinks.
Possible cause
There is water or fat stains on the
control panel.
The other zones consume the maxi‐
mum available power.
Your hob works properly.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
You covered the control panel.
You use a very tall pot which blocks
the signal.
The cookware is too large or you put
it too near to the controls.
The sounds are deactivated.
The cookware is in a wrong position
on the flexible induction cooking
area.
The diameter of the bottom of the
cookware is incorrect for the activa‐
ted function or function mode.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone or
the zone is not fully covered.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
Remedy
Clean the control panel.
Reduce the heat setting of the other
cooking zones connected to the same
phase. Refer to "Power management".
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Remove the object from the control
panel.
Use a smaller pot, change the cooking
zone or operate the hood manually.
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Place the cookware in the correct posi‐
tion on the flexible induction cooking
area. The position of the cookware de‐
pends on the activated function or
function mode. Refer to "Flexible in‐
duction cooking area".
Use cookware with a diameter applica‐
ble to the activated function or function
mode. Refer to "Flexible induction
cooking area".
Refer to "Daily use".
Put cookware on the zone so that it
fully covers the cooking zone.
Use suitable cookware. Refer to "Hints
and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
ENGLISH 21