Using The Dip Switch For Setup - Sony SLS-1A Bedienungsanleitung

• Import Beam Data
You can import sound simulation data from
EASE Focus 3 and FIRmaker 3D.
EASE Focus 3 and FIRmaker 3D can be
downloaded from the website of AFMG
Technologies GmbH at:
https://www.afmg.eu/en
• Steering/Spread
Adjust the beam steering angle (between
-40 degrees and +40 degrees) and the opening
angle (between 0 degree and 90 degrees).
Sound tab
Make setup of the equalizer and others.
Network tab
You can view the MAC address or IP address of the
Dante device or the speaker.
Device tab
You can view the connection state, apply software
updates to the speaker, or restart the speaker.
Using the DIP Switch for
Setup
Instead of the Line-Array Speaker Manager
application, you use the DIP switch on the rear of the
speaker to make beam control setup of the speaker.
Changing the Number of Dante Input
Channels (1 Channel/8 Channels)
To select 1-channel input, set the left-most slider of
the DIP switch to the lower position.
To select 8-channel input, set the left-most slider of
the DIP switch to the upper position.
Note
• While 8-channel input is selected, no beam control is
applied to the speaker.
• After you change the number of Dante input channels,
turn off the power to the speaker and then turn it back on.
16
GB
Changing the Beam Control Setup
Using the 4 sliders to the right of the DIP switch, you
can select one of the 6 preset beam control settings.
Note
• Before making beam control setup with the Line-Array
Speaker Manager application, set the sliders of switches 5,
6, 7, and 8 of the DIP switch to the lower positions.
For
For vertical
horizontal
placement
placement
1
2
3
4
5
6
DIP switch
configuration