Settings - Atag VA2214MP Gebrauchsanweisung

Settings

1. Open the door and press
2. To open the dishwasher's settings menu, press and hold
display.
3. Press
to step through the settings menu.
4. Press
to step through the alternatives.
5. Confirm the selected setting by pressing
6. To exit the menu, step through it or press
Open the dishwasher's settings menu
Select alternative
Settings
Sounds
Rinse aid
Water hardness
20
.
Alternatives
2:00 - 2:03 A beep confirms that the control panel has been pressed.
(00 Off) A beep indicates when a dishwashing program has ended.
Error messages are always indicated by a loud buzzer.
3:00 - 3:05 Setting for rinse aid dosage. The rinse aid dispenser can
be adjusted between 00 (Off) and 05 (High dosage).
(00 Off)
Increase the rinse aid dosage:
If the dishes have water marks.
Decrease the rinse aid dosage:
If the dishes have a sticky white/blue film.
If the dishes are streaked.
Build-up of foam. If you have very soft water, the rinse
aid can be diluted 50:50 with water.
Pre-selected at factory: 04
4:00 - 4:09 Adjusting the water softener. Select a setting depending
on the hardness of the water supply. It is important that this
(00 Off)
setting is correct!
See Water hardness in the chapter Before washing for the
first time.
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 00. The water softener is
deactivated and no salt needs to be added.
Pre-selected at factory: 04
and
.
.
until SEt is shown on the
Confirm / Next setting