Cleaning And Maintenance; Wear Parts - Fiap LightFountain ACTIVE Gebrauchsanleitung

GB

CLEANING AND MAINTENANCE

Before each cleaning and maintenance, make sure that the device is switched off and
disconnected from the power source.
The filter housing and the barrel unit must be cleaned at regular intervals. The cleaning
interval depends heavily on the degree of soiling. The degree of pollution can vary signifi-
cantly from water to water. First open the filter basket and take out the pump motor.
To clean the rotor and the internal parts, also remove the corresponding screws and
pull off the cover of the motor housing. The rotor can then easily be pulled out of the
liner and cleaned. Do not use any sharp-edged objects such as Steel brushes, use a soft
sponge instead. Stubborn dirt such as The best way to remove limescale deposits is with
PUMP CLEANSER
premiumcare
pump is cooled by the water. Always make sure that the pump works against as little
resistance as possible. If the flow rate is reduced (e.g. hose diameter too small, ball valve
in the line, delivery height too high, contamination, etc.) the operating temperature rises
significantly. From 55 degrees Celsius, more lime is deposited on the pump motor. In the
worst case, this layer of lime becomes so thick that the rotor runs very stiffly, jams
and the motor burns out. Damage caused by soiling and calcification is excluded from
the guarantee. The user has to properly maintain and clean the pump depending on the
amount of dirt and limescale. After cleaning, reassemble the pump in reverse order.
Observe the relevant product videos on the subject of cleaning and
maintenance in our
Youtube channel: https://www.youtube.com/user/FIAPGmbH

WEAR PARTS

The pump must not run dry. The dry run leads to rapid wear and tear and damages the
pump in the long term. Use in polluted water with solids and particles also leads to pre-
mature wear and has a negative impact on the service life of the pump. Algae or others
Plants that wrap around the filter basket and can quickly clog it lead to reduced wa-
ter flow and increased wear. We recommend operating the device exclusively in bodies
of water without plants, or to ensure that no plants can be sucked in. Wear parts are
excluded from the guarantee. Appropriate cleaning and care reduce wear and tear on
the device.
REPAIR
If the cables or the housing are damaged, the motor cannot be repaired and must the-
refore be replaced. The running unit (rotor + impeller) is available separately as a spare
part.
If you have any questions or problems, please contact a qualified electrician or your spe-
cialist dealer for your own safety.
pump cleaner. If there is sufficient flow, the
WATER FEATURES
9