Storage; Maintenance - Scheppach 58062079969 Originalbetriebsanleitung

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
power tool to protect it from dust or moisture. Store the
operating manual with the power tool.

13. Maintenance

Changing the oil (fig. 6)
The engine oil change should be carried out while the
engine is at operating temperature.
• Have a suitable container that will not leak ready for
the oil change.
• Open the engine cover (5).
• Remove the oil dipstick (19).
• Open the oil drain screw (c) and drain the warm
engine oil into the collection container beneath the
outlet drain.
- Tilt the generator slightly so that more oil can be
drained.
• Fill engine oil up to the top marking on the oil dip-
stick.
• Dispose of the used oil properly. Hand over your
used oil at a collection point. Most filling stations,
repair workshops or recycling centres take used oil
back free of charge.
Air filter
Frequent cleaning of the air filter prevents malfunc-
tions.
Cleaning filter and replacing the air filter (fig. 9 - 13)
• The air filter must be cleaned every 30 operating
hours.
• Remove the engine cover (g).
• Remove the air filter cover (h).
• Remove the filter element (20).
• Clean the filter element with clear water and allow it
to dry well before reinstallation.
• The re-assembly takes place in reverse order.
m WARNING
Do NOT use petrol or cleaning solvents with a low
flash point to clean the air filter element. This could
result in fire or explosion.
NOTE
Never run the engine without an air filter or with a dam-
aged air filter. This would allow dirt into the engine,
which would result in severe damage to the engine. In
this case, the seller and the manufacturer disassociate
themselves from any warranty claims.
Changing the diesel filter (fig. 7)
The diesel filter must be changed when the inside of
the filter is contaminated or impurities can be seen. In
order to change the filter and collect diesel in the tank,
a funnel and an empty diesel container are required.
Undo the metal bracket on both sides of the filter. Im-
mediately insert the fuel hose through the funnel into
the diesel canister and observe the diesel flow until
no diesel drains. Remove the filter with impurities and
throw it away. Install a new filter.
Emptying the tank
• In order to empty the tank, first proceed as you
would when "Changing the diesel filter".
• After removing the diesel filter, lead the diesel fuel
from the tank via the funnel into the diesel canis-
ter. (ATTENTION: Ensure that the diesel canister
is large enough to collect the remaining fuel in the
tank!).
• After draining is complete, carry out assembly as de-
scribed under "Changing the diesel filter".
Please provide the following information in the
event of any enquiries:
• Data of machine type plate
• Data of motor type plate
Important note in the case of repairs:
When returning the device for repair, please ensure for
safety reasons that it is free of oil and fuel when it is
sent to the service centre.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Air filter, diesel filter, battery, injection
nozzle
* may not be included in the scope of supply!
www.scheppach.com GB | 27