Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-12
Assembly
Assembly
Requirement for assembly
You have read chapter "Safety" on page EN-3
and understand all the safety notices.
Installing check valve
(4)
Pins
• Place the two halves of the check val-
ve (4) into the opening on the top of the
Exhaust hood (1).
Make sure that the pins on the valve are
facing outwards.
Assembling the exhaust hood
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas stoves.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
(4)
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Hold the exhaust hood (1) against the wall
so that the distance to the stove is at least
65 cm and the centre of the exhaust hood
aligns with the guide line.
3. Mark this point.
4. Put the exhaust hood aside carefully.
guideline
Werbung
Inhaltsverzeichnis
