Setting The Volume - Renkforce IR-1600 Bedienungsanleitung

• After scanning, all WLAN networks found are listed on the display of the Internet radio. Select the desi-
red WLAN network.
Confirm the selection of the WLAN network by pushing the setting wheel or the button „
remote control.
• Now enter your WLAN password. This is the password you have assigned in the router or access port in
the respective WLAN setting menu.
Turning the setting wheel or using the 4 arrows of the IR remote control, you can select the letters, num-
bers and special characters, as well as the three buttons „BKSP", „OK" and „CANCEL".
The button „BKSP" (= „Backspace" = one character back) permits deleting the last character;
with „OK", you confirm input of your WLAN password, and „CANCEL" takes you back to the scan
for available WLAN networks.
Confirm your selection as usual with the setting wheel or the IR remote control.
• After confirming input of the WLAN password with „OK", the Internet radio will try to establish a WLAN
connection. This may take several seconds.
If the connection is successful, the display shows the corresponding message for confirmation; then the
setup wizard is ended.
If no connection can be set up, an error message appears and the Internet radio will switch back
to the input field for the password.
The button „BACK" (M) will take you back to the selection of the WLAN network, if required.
d) Setting the Volume
The volume can be set via the buttons „+" and „-" (4) of the IR remote control or alternatively via your
amplifier.
42
" (2) of the IR