Modifying The Co 2 Values - Sime UNIQA REVOLUTION 25 Installations-, Gebrauchs- Und Wartungsanleitung

– press the > button again to run the boiler at maximum power
again
– press the button y to exit the "Chimney sweeper Proce-
dure". The boiler water delivery temperature will appear on
the display
– close the taps opened previously and check that the appliance
shuts down.
CO values
2
Type of gas
max
CO
2
min
7.9 Modifying the CO
Should the CO values read differ from those in the table, modify
2
"PAR 73" as follows:
– keep the flue gas analyser inserted in the take-off point on
the outlet ducts
– go into the parameter section by pressing the buttons
t (for approximately 5 seconds) at the same time until "PAR
(parameter number) and the value set (0) appears on the
01"
display
– press and hold the t button and scroll through the param-
eters until you reach "PAR 15" (maximum heating output)
during the winter season, or parameter "PAR 20" (maximum
DHW output) during the summer season
– press and hold the < button to change the value to "0" (force
minimum power)
– exit the parameter section by pressing and holding down the
buttons r and t at the same time
onds) until the delivery temperature is displayed. The modi-
fied value will be stored automatically
– go into the parameter section by pressing the buttons
t (for approximately 5 seconds) at the same time until "PAR
(parameter number) and the value set (0) appears on the
01"
display
– keep the button t pressed and scroll through the parameters
until reaching parameter "PAR 49"
G20 G31
3,0 - 3,5 3,7 - 4,2
2,1 - 2,5 2,8 - 3,2
values
2
r
(for approximately 5 sec-
r
– press and hold the button
– the modified value will be stored automatically
– press and hold the
ters until you reach "PAR 73" (default value "20")
– increase or decrease "PAR 73" one unit at a time using the
or < buttons respectively, checking combustion
– the modified value will be stored automatically
and
– after the CO values have been modified, set "PAR 15" or "PAR
2
(depending on which was modified previously) back to
20"
– or the most suitable heating power
"100"
– exit the parameter section by pressing and holding down the
buttons r and t
until the delivery temperature is displayed.
and
> to set the value at "49"
t button and scroll through the parame-
(approximately 5 seconds)
at the same time
>
41