Bright 016747 Bedienungsanleitung Seite 30

EN
STATUS LIGHT
• The status light flashes red when the
ice-cream maker is in standby mode.
• The status light flashes goes green when
the ice-cream maker is in run mode.
• The status light flashes green when the
ice-cream maker is in cooling mode.
COOLING FUNCTION
Cooling mode is activated to prevent the ice
cream melting if it is not going to be used
or frozen immediately. The ice-cream maker
will continue to switch off automatically for
ten minutes and then run for six minutes to
maintain the fresh taste and texture of the ice
cream if no steps are taken when the ice-cream
making process is completed. This function is
active for 1 hour. During this time the status
light flashes green. Ten short audio prompts
are given when the ice-cream making process
is completed, the ice-cream maker goes into
standby mode, and the status light flashes red.
MOTOR SAFETY FUNCTION
The mixer can be blocked when the ice cream
gets harder and the motor safety function trips
to stop the motor.
COMPRESSOR SAFETY FUNCTION
If the ice-cream maker is switched off in
ice-cream making mode or cooling mode,
it cannot be started again for about three
minutes to protect the compressor. When the
plug is plugged in the ice-cream maker starts
automatically, without delay.
USE
ICE-CREAM MAKING
1. Pour the well prepared recipe ingredients
in proportion into the removable bowl,
then have a uniform mixing.
FIG. 2
30
2. Put the ice-cream container in the ice-
cream maker. Fit both ends of the handle
in the slot in the upper casing.
1. Installation position for ice-cream
container
FIG. 3
3. Fit the transparent lid and motor unit.
FIG. 4
4. Fit the mixer on the transparent lid and
motor unit.
FIG. 5
5. Put the mixer with the transparent lid
and motor unit on the ice-cream maker
and fit the mixer motor on the ice-cream
container. Turn the mixer unit clockwise to
lock, so that the arrow on the unit points
to the lock marking.
FIG. 6
6. Plug in the plug and press the power
switch for one second to start the ice-
cream maker. The status light flashes red.
Press the button START/STOP. The status
light flashes green and the ice-cream
making process starts.
7. Press the power switch button for one
second to switch off the ice-cream maker
when the ice-cream making process is
completed.
8. Turn the transparent lid and motor unit
anticlockwise. A faint scraping noise is
heard. This is perfectly normal. When the
arrow on the transparent lid points to the
marking for unlocked position, lift out the
mixer unit and the ice-cream container.
FIG. 7
NOTE:
• Before using, clean all parts that come
into contact with the ice-cream mixture
thoroughly, such as the cooling unit,
ice-cream container, mixer and lid etc.
• Switch off the ice-cream maker and pull
out the plug. Place the ice-cream maker